Why use thermal oil instead of steam?

Thermal oil reaches 300 °C or more at near-atmospheric pressure, so you avoid high-pressure vessel duty, water treatment, blowdown losses and freezing risk. It suits precise, high-temperature process heating.

How often should thermal fluid be tested?

At least annually, and every six months on high-duty plant. Testing is far cheaper than a coil failure caused by degraded fluid.

Can you replace the fluid without a long shutdown?

Yes — a planned flush and change-out is usually a two- to three-day job with the correct flushing fluid and disposal arrangements.

← Thermal Oil BoilersErasmuskloof · Pretoria

Thermal Oil Boilers Repair
in Erasmuskloof

Thermal oil boiler repair, maintenance and annual inspection in Erasmuskloof and the wider Pretoria area. Same-day response for commercial and industrial plant across Gauteng.

Capacity

100 kW – 15 MW

Fuels

Natural gas · LPG · Diesel · HFO · Biomass · Electricity

Local Service

Thermal Oil Boilers in Erasmuskloof

Our certified technicians service thermal oil boilers across Erasmuskloof and the Pretoria region — from commercial bakeries and ovens to asphalt and bitumen plants. We carry common burner spares, safety valves and controls for major brands including Babcock Wanson, Cyclotherm, Thermax, Unical. Annual inspection, combustion analysis, tube cleaning and emergency breakdown response are all available in Erasmuskloof.

Brands

Thermal oil boiler brands serviced in Erasmuskloof

Babcock Wanson
Cyclotherm
Thermax
Unical
Garioni Naval
Heat Transfer Engineering

Our Service

What we cover in Erasmuskloof

Thermal fluid sampling and degradation analysis
Fluid change-out, flushing and system clean
Coil inspection, cleaning and leak repair
Circulation pump and mechanical seal service
Expansion and deaerator vessel maintenance
Burner service and combustion tuning

Troubleshooting

Common thermal oil boiler faults in Erasmuskloof

Fluid degradation and carbon build-up+
Likely causes
- Film temperature exceeding the fluid limit
- Low flow through the coil
- Fluid past its service life or contaminated
What to check
Send a fluid sample for analysis — viscosity, flash point, carbon residue and low boilers tell the full story.
When to call us
As soon as analysis flags degradation; carbon deposits cause hot spots and coil failure.
Loss of process temperature+
Likely causes
- Fouled coil surfaces
- Pump wear or cavitation
- Air or moisture in the fluid circuit
What to check
Compare pump differential pressure and flow with commissioning data.
When to call us
If venting and a pump check don't restore temperature, the coil likely needs cleaning.
Fluid leaks and smoking joints+
Likely causes
- Failed flange gaskets under thermal cycling
- Pump seal wear
- Coil pinhole from internal corrosion
What to check
Inspect flanges and pump seals when hot — hot thermal oil leaks are a serious fire risk.
When to call us
Immediately — shut down and call out; thermal oil above its flash point ignites readily.

FAQ

Thermal oil boiler questions — Erasmuskloof

Why use thermal oil instead of steam?
+
Thermal oil reaches 300 °C or more at near-atmospheric pressure, so you avoid high-pressure vessel duty, water treatment, blowdown losses and freezing risk. It suits precise, high-temperature process heating.
How often should thermal fluid be tested?
+
At least annually, and every six months on high-duty plant. Testing is far cheaper than a coil failure caused by degraded fluid.
Can you replace the fluid without a long shutdown?
+
Yes — a planned flush and change-out is usually a two- to three-day job with the correct flushing fluid and disposal arrangements.

Nearby Areas