Electrode boiler repair, maintenance and annual inspection in Springs and the wider East Rand area. Same-day response for commercial and industrial plant across Gauteng.
Local Service
Our certified technicians service electrode boilers across Springs and the East Rand region — from hospital clean steam to food and beverage clean steam. We carry common burner spares, safety valves and controls for major brands including Marshall Fowler, Cyclotherm, Allmech, Thermax. Annual inspection, combustion analysis, tube cleaning and emergency breakdown response are all available in Springs.
Brands
Our Service
Troubleshooting
Likely causes
What to check
Measure feedwater conductivity against the nameplate range, and log kW draw versus setpoint over a full cycle.
When to call us
Conductivity dosing and electrode work are specialist tasks on a live HV vessel — do not attempt on site.
Likely causes
What to check
Isolate and log insulation resistance readings; look for tracking marks around the bushings.
When to call us
Immediately — repeated earth faults on an electrode boiler are a serious electrical hazard.
Likely causes
What to check
Compare make-up water metering against steam output to quantify the loss.
When to call us
When water and chemical costs rise without a matching production increase.
FAQ
No combustion means no flue, no emissions licence and no fuel storage — plus close to 99% energy conversion. They suit sites with clean-steam requirements or restricted combustion approvals, and can be run on off-peak tariffs.
Conductivity typically has to sit in a controlled band (often 200–400 µS/cm). Too low and the boiler cannot reach load; too high and it overloads. We manage dosing, blowdown and testing under contract.
Typically 5–10 years depending on water treatment discipline and duty. We inspect them at each major service and report on remaining life before failure interrupts production.
Nearby Areas
Send nameplate photos and we quote within 24 hours.
Get a Free QuoteCall 067 603 9306